Original topic:

Galaxy Watch 7: no linear acceleration sensor??

(Post creation time:  

1 year ago

)

1296 Views

V

vaar

Constellation

last edited

 

1 year ago

 

in

 

I am the developer of an app that uses Sensor.TYPE_LINEAR_ACCELERATION to measure the linear acceleration of the device (i.e., without gravity). It works fine on Galaxy Watch 5 and 6... but Galaxy Watch 7 gives nonsense values:

6.6893997 7.055712 7.599196
6.706159 7.065289 7.577648
6.679823 7.0461354 7.6135616
6.6989765 7.050924 7.565677
6.730101 7.0485296 7.5824366

(watch is on the table, should be values close to 0 on all three axes).

What is happening? Is Sensor.TYPE_LINEAR_ACCELERATION not supported on Galaxy Watch 7???

Edit: BTW, when I restart my app the values change completely. Watch is at rest on the same position on the table, I restarted my app and now I get:

0.50038815 8.585608 15.02601
0.48602295 8.561666 14.939818
0.48841715 8.585608 14.982914
0.49320555 8.604761 15.028404

**bleep**!? These are the raw values obtained in onSensorChanged(event: SensorEvent).

    •  

      Selected Answer

      S

      Samsung_Moderator

      Community Manager

      1 year ago

       

      in

       

      Thank you for reaching out, vaar and seast. As you are developers of an app that you are experiencing symptoms with on the Galaxy watch 7, I would recommend reaching out to the Samsung Developers community, they will be able to better assist you in troubleshooting your app: https://forum.developer.samsung.com/

      This comment was created from this

      reply

      0 likes

    • V

      vaar

      Constellation

      1 year ago

       

      in

       

      BTW, if anyone can install Sensors Info (Wear OS) from the play store and please tell me your Raw Sensors Data -> Linear Acceleration -> Values I would be grateful. It should report values close to 0,0,0 with the watch not moving.

      0 likes

    • S

      seast

      Constellation

      1 year ago

       

      in

       

      I am getting exactly the same issue. My sensor code works fine on load of Android Phones and the Watch 5 and 6 but the TYPE_LINEAR_ACCELERATION values returned by the Watch 7 a way too high when it is just sitting on the desk. Did you get any response from Samsung on this?

      0 likes

      S

      Samsung_Moderator

      Community Manager

      1 year ago

       

      in

       

      Thank you for reaching out, vaar and seast. As you are developers of an app that you are experiencing symptoms with on the Galaxy watch 7, I would recommend reaching out to the Samsung Developers community, they will be able to better assist you in troubleshooting your app: https://forum.developer.samsung.com/

      0 likes